Coloplast SenSura Click Two-Piece Convex Light Standard Skin Barrier With Belt TabsColoplast SenSura Click Convex Light Standard Wear Skin Barrier with Belt Tabs Two Piece Ostomy System The Coloplast SenSura Click Convex Light Skin Barrier is a two piece ostomy wafer designed with a mechanical coupling system that provides an audible click for secure attachment. It is designed for flush or slightly retracted stomas where shallow convexity is required to improve output direction and reduce leakage risk. KEY FEATURES Mechanical click

Coloplast SenSura Click Convex Light Standard Wear Skin Barrier with Belt Tabs | Two-Piece Ostomy System

The Coloplast SenSura Click Convex Light Skin Barrier is a two-piece ostomy wafer designed with a mechanical coupling system that provides an audible “click” for secure attachment.

It is designed for flush or slightly retracted stomas where shallow convexity is required to improve output direction and reduce leakage risk.

KEY FEATURES

• Mechanical click-lock coupling system for secure pouch attachment
• Convex Light profile for shallow outward pressure support
• Double-layer adhesive system for skin protection and moisture balance
• Belt tabs for additional stabilization support
• Available in cut-to-fit and pre-cut configurations
• Color-coded flange sizing system for matching pouch compatibility

SKU SYSTEM (NORMALIZED)

40mm Flange (Green)

• SKU 11011 — Cut-to-fit — 15mm to 23mm stoma range
• SKU 11012 — Pre-cut — 22mm stoma size

50mm Flange (Red)

• SKU 11021 — Cut-to-fit — 15mm to 33mm range
• SKU 11022 — Pre-cut — 25mm
• SKU 11023 — Pre-cut — 28mm
• SKU 11024 — Pre-cut — 31mm

60mm Flange (Blue)

• SKU 11031 — Cut-to-fit — 15mm to 43mm range
• SKU 11032 — Pre-cut — 35mm

70mm Flange (Yellow)

• SKU 11041 — Cut-to-fit — 15mm to 53mm range

Important: Flange color determines pouch compatibility and system coupling size. Incorrect color matching is a primary cause of attachment failure.

WHEN TO USE THIS SYSTEM

• Stoma is flush or slightly retracted
• Leakage occurs at base of wafer due to poor output direction
• Need secure two-piece mechanical coupling system
• Require belt stabilization for added security

FIT & GEOMETRY WARNING (CRITICAL)

Convex Light is not a cosmetic feature — it is a mechanical correction tool for stoma positioning.

If the stoma is recessed and flat barriers are used, leakage will occur regardless of adhesive quality.

Belt tabs provide additional stabilization but do not correct incorrect convexity selection.

If unsure about convex vs flat selection, confirm before ordering.

866-218-0902

FAQ (DECISION ENGINE — HIGH INTENT)

What does “Convex Light” mean?

It is a shallow convex shape designed to apply gentle outward pressure to help protruding or stabilize flush stomas.

When should I use convex instead of flat?

Use convex when output is undermining a flat barrier or the stoma does not sufficiently protrude above skin level.

What is the click system?

It is a mechanical locking ring that produces an audible click when the pouch is securely attached to the barrier.

Do belt tabs improve seal performance?

They improve mechanical stability but do not replace correct barrier selection or proper sizing.

What causes most leakage in this system?

Incorrect flange size or incorrect convex vs flat selection — not adhesive failure.

NEED HELP SELECTING?

Correct convex selection and flange sizing directly determines wear time and leakage prevention success.

866-218-0902